So here is a question related to the module.
Now we need to make a dynamic blog with this sync and drawing and this dynamic blog should be made in
such a way that its length can be increased to an increment value of three inches in either direction
and the center of this dynamic block should be fixed.
Also ensure that the maximum length of this blog goes to twenty five inches and the minimum remains
at nine inches
to start making this blog.
I'll go to this create blog and select Name so let's name it as Sync and now click on pick point now
and select at this point the middle point as the pick point and as you can see that I'm not only selected
because objects SNAP is off so I'll go to objects snap and select midpoint.
Also I have this dynamic input selected which I don't want so I'll go to this customization select dynamic
input and turn it off.
Now I'll go to this point now I'll click on select objects and select all of it and presenter and I'll
make sure allow exploding is checked and also open in block any dots check because we want to make more
modifications in this.
Now click on.
Okay so here it is a block in this block Ed environment.
Now I'll start by adding linear parameter.
So here on the panel me just now we have this linear so select this linear click on the first point
here the midpoint and the second point here and place it somewhere over here.
Here also we can turn this dynamic mode and now go to actions now will apply.
This is Stretch action.
So for this select the distance one parameter and now click on the point here.
Now make the stretch frame so I'll make this a stretch frame to include the circle.
And most of these objects now make a selection of objects so once again and click on this point and
select it in such a way that the circle and the parameter are all included.
Now presenter so one of the actions that added We need to add one more action for the second side.
So I would select stretch again.
Click on this barometer.
Now select this point and this time I'll look at this point and I'll once again make this frame just
like this.
Once again click some arrow here and make this frame and press enter.
There we have it.
So now we have made this we can test the block so click on Test block click on it.
We have the grips so we can stretch it.
But the central point is not fixed.
And also the increments are not added so we need to fix these two properties.
So I'll click on close test block and I'll select distance one barometer.
All right click and select properties.
Now here we have this properties ballot we can now change the properties so I'll simply scroll down
here and let's expand this property ballot a little bit.
So here in this case you'll see the distance type is set to None selected and change you to increment
and we want an incremental value of three inches of type three inches in this and here the minimum value
should be nine inches and the maximum should be twenty five inches.
So there we have it.
Now also the Base locations should be the midpoint so your change it to midpoint.
Now we have all the values set so let's close it.
Let's test the block so once again l selected take on any of these grips.
And yes now we can increase it within increments of three inches.
And also the center remains fixed in these cases.
So there we have the final dynamic block.
So let's now close it.
Let's see if the block hand closed the block Ed..
And here we have the final dynamic block according to the requirement.