All right so in this video make this a simple to practice drawing.
So we'll start with the line tool and for that and this line command and click anywhere in the screen
to start the line and then make sure that it is horizontal when the line is horizontal you'll see this
green tracking vector.
And if there's green tracking it is not visible even after making a horizontal line.
Then go to the status bar and click on this polar tracking.
So that should make your green line visible.
Now once the green line is active and to the left which is 14 and press enter.
Now here we have this small line.
Let's zoom in a little bit and there we have it.
Now move it in the opposite direction.
And to the left of three units move to the left again three moved the top four and that's it.
Now press enter to exit the command now press enter again to start the command from the side.
And now we'll add a line of length 10 and press enter.
Now again move to the right and enter a line of lenth full unit's press enter and again move to the
right.
Enter a length of 2.4 for the line.
Press Enter now it with this point.
OK.
So now we have these details.
Let's now make a circle here.
So I go to circle and I'll select two points circle.
Now at this point and then this end point just make sure you click on the end point not on the midpoint.
So there you have it.
Now I'll go to flet and radius the radius is three.
So I select three press enter.
And now the first line second line.
So there we have it the filler of radius 3.
Again I'll go to circle select center radius and go to the same center of this circle now and a radius
of 1.6 and police and.
All right so now we can clean this drawing a little bit.
So I'll go to trim and press enter and select these two geometries.
Well we cannot trim those because that's a single segment.
So we need to raise it to select and raise it on rates.
Now we need to add the hexagon the final trip.
For that I load a polygon and now enter a number of sites you know this is a hexagon So Type 6 and press
enter.
Now I specify center Well the center is the center of the circle are in this case.
And now you can see that the distance between two pieces of this hexagon is two.
So we can use inscribed in this case.
And obviously if you want to know more about this Enscribe circumscribed circle you can go to the Odegaard
course and find out more about this.
All right.
So now I'll go to inscribed in a circle.
And entered the radius of one.
So in this case since the total distance is to from one were to other so the radius will be half of
that which is 1 press enter and there we have it.
The final hexagon.
And that also computer find the.