OK.
And now this model is complete Let's make this drawing using all the tools which we have learned so
far and for making this we are going to use that as a tool to be specific.
We'll use the circular area which we have learned here.
So I'll start with the circle command.
So I got to draw a panel select the fly out and select the center radius circle.
Now click at any point in the drawing area to start it and enter a radius off to a unit and press enter.
Now presenter again to repeat this command and go to the same center.
And this time and radius of unit and press enter.
So there we have it two concentric circles.
Now we need to go to the circle to Lagann click on this quadrant.
And now again make another circle with a radius of point eight unit and press enter.
Now we need to trim this part.
So I'll go to trim tool press enter and remove this portion.
Now we need to make the Adye.
So the fly out here and select Buhler addy.
Now click on this part.
Press enter and now you can the center which is here so in this drawing we have 11 instances and in
total we need to make 12 and stands because one of that is removed and the groove has been made instead
of that and select here as well as number of items and press enter.
So here we have it.
Now make sure as we'll see it is unchecked and then click on PLO's addy.
Now we need to clean this geometry.
So I go to trim press enter and remove these portions.
They are no longer required in this in geometry.
OK so now we need to make the final groove here.
So as simply it is this portion it is no longer required here.
And here we have already trimmed this portion which we should not have trimmed.
So in order to extend it you can go to the mortified panel and here select the extend tool and press
enter.
Now click on this portion and there we have it.
It is now extended back.
OK so now I'll go to the line tool.
Click on the center and make a straight line.
It should be long enough to pass this circle completely.
Now go to offset and then turn off the distance off point five.
And press enter.
Now click on this line and click up.
Then click on this line and click downwards and press enter.
Now gold trim tool press enter and remove the complete portion and this complete portion.
Also zoom into this area remove this part and remove this part.
Now remove this line.
It's no longer required.
There we have it.
The final geometry as the dimensions mentioned here.