In this video I will tell you about finding distance radius angle and coordinates from the simple article
geometries.
And for that I only use the symbol to the drawing.
Now you're in this drawing we have the circle of simple lines.
And also this land line and we will find different properties of this and geometry using the inquiry
commands inquiry commands or simply the commands which can be used to find these values and you can
find those commands here on the utilities panel to go to this utilities panel.
And here you'll see this fly out from this fly out select the distance option first so you can also
start this distance tool from the command.
Now once the command is active click on the first point from where you want to start distance measurement.
And in this case we want to start distance measurement from this point.
I'll click on the end point which is this one in this case and we have the results over the command
line.
Now expand this command line and here you'll see that the distance is twenty eight units.
Also the angle in x y plane is 35.
That means the angle which this line line is making with respect to the positive side of x x.
So if a line is drawn here in a completely horizontal way then the angle at which this line is making
with that line is 35 unit.
Also we have some additional values like the delta delta x y and z.
So that simply means that the coordinate value of the final point when subtracted the coordinate of
the initial point will have this result.
So the x coordinate of this point minus escorted of this point will be twenty two point nine 363 three.
Similarly the y coordinate of this point minus Y corner of this point will be off this value.
Now to exit this command simply press Escape key in a similar way.
You can use other options of this fly out to find other values for example here we have the radius selector
radius and now select an arc or circle.
So here we have the Circle let's click on it and we have the radius.
And not only the radius we also have the diameter of this circle.
Similarly you can repeat the radius to simply by selecting the radius option from the command line here
also.
And now click on this arc and the radius is six unit.
The damage is in it for this arc.
So let's now press Escape key to get back to the geometry.
And now we'll go to the utilities panel and select the remaining options.
So the next option is angle.
Now when you want to find only the angle of any line then you can select this command.
Now in this case you can select good geometry and I'm selecting this line and select the second line
or the second geometry with respect to which you want to find the angle.
So I select this one.
And now the angle in between these two geometries is 125 degrees as mentioned here.
So the included angle on this side the smaller side will be 125 degrees.
Now let's repeat it once again so I will select this angle.
Now I will select this line and I'll click on this line and here in this case the included angle here
will be one 45 degrees.
So in this way you can find angle between the geometries as well.
Now using inquiry commands you can also find the coordinate values of any geometry for example in this
case we don't know the coordinate of the center of the circle.
And if you want to find that out simply go to the utilities panel and select this Iby point option.
You can also use its Kamandi equivalent which is IAB and now click at the point for which you want to
find the coordinates.
Click here and now here we have the current value of the x value in the Y and obviously the z value
will be zero as we are dealing with x and y axis only in this case.
So in this way you can find a distance radius angle and coordinate values of any enjoyment tree using
the inquiry tools.