So here's a question related to the model we need to create an associative hatch in a rectangle of lint
ten and five minute with these properties.
The pattern should be NC 31.
The origin of that pattern should be lower left lower decks of the rectangle and the scale should be
any scale which is clearly visible and the scale in which the lines of the hatch pattern are clearly
visible.
So here we have the drawing.
Let's start with the rectangle tool.
So I'll click on rectangle and click at a point now and type at and a of 10 and over to 5 unit and press
enter.
So there we have it.
Now we need to add the badan here.
So for that and go to this Hache tool and make sure this NC 31 is selected Also we need to ensure that
this associative option is checked.
So with these two options click inside this area and here we have it the hatch is quite clearly visible
but if it is not visible in your case you can go to this scale and change it.
In this case and change it to two and press enter.
There we have it.
Now it's widely spaced.
And now we need to change only one property here.
We need to change the origin.
So in this case the origin should be lower left which is at this point so let's zoom into this area.
So here you can clearly see that the origin is not clearly specified and the line is starting from somewhere
on this or is on the line.
So we need to ensure that this line should start from this what next.
For that I click on set origin and click on this word x.
There we have it.
Now it's starting from the required point.
Now let's zoom out and there we have it.
The final Hatch Brettan.
So let's now look on close creation and there we have it the drawing as per the requirement.